Tag Archives: carving

Information On Ski Carving Tehnique

Ski carvingCarving is when the edges cut into the snow properly that the skis do not slide sideways but go straight along the length. These are some ski carving technique. For you to initiate the curve, you should be pointing straight down the slope by rolling your knees over the ski edge then dig deep into the snow and steer the ski across the slope. The ski should be put on the edge so that when you start to turn, the skis will cut into the snow and not slide. The most common mistake that is made by people who are learning how to carve is they do not roll their knees.

When you are learning how to carve well, your body weight should be transferred to the middle of the outside ski. The body needs to be more upright than your legs so that the edges can be dug into the snow as much as possible. This also makes it easier to switch between turns as the body does not need to move so far. More experienced skiers will use the inside ski as they are carving to an extent although this is only when the conditions permit them to really dig on the edges of both skis into the snow.

Carving is not always possible. For you to carve, you will need to have the right equipment and the right conditions. The snow needs to be soft enough so that the edges can dig into it but hard for it to hold the sideways forces that you will have created. People find it really hard to carve in icy conditions as it is not easy to cut into the snow. The sharpness of the edge of your ski also makes a big difference. The sharper the edges are, the easier they will dig into the snow.

Find out more here